Ballast Resistor (6 X 4R7) cresta Required to add CAN communications

Required to add CAN communications & power to recently released G4X Plugin ECU’s which have the new 4 Pin powered CAN connector (not the older 5pin CAN connector)

Flow Rate: 440lph

PFF60-1422

Auxiliary Injection: - Additional injector stage control using unused fuel outputs for additional fuel stages or water/alcohol

ECU values

Ballast Resistor (6 X 4R7) cresta Required to add CAN communicationsFor use with low impedance injectors. Compatible with injectors with impedance between 2 and 6 Ohms. Please contact us if you are planning on using injectors with an impedance of less than 2 ohms. Includes set of 6 x 4. 7ohm 25w resistors mounted to a heatsink. These are also sold in a set of 4. Note that injector ballast resistors get quite hot at high injector duty cycles. These should stay mounted on the supplied heat sink and be bolted to the